Siyah Buton Kapağı (Kep), KSA ve KSL Serisi Yalıtımlı Tact Switch İle Kullanım

RS Stok Numarası: 787-4833Marka: C & KÜretici Parça Numarası: BTN K03 90IMPA: 0
brand-logo

Teknik Belgeler

Özellikler

Başlık Rengi

Siyah

Aksesuar Tipi

Button

Marka

C & K

Şununla Birlikte Kullanım İçin

KSA ve KSL Serisi Yalıtımlı Tact Switch

Menşe

France

Ürün Ayrıntıları

Electronic Converter for MR16

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.

Stok bilgileri geçici olarak kullanılamıyor.

Ayrıntılı bilgi için iletşime geçiniz

Stok bilgileri geçici olarak kullanılamıyor.

17,63 TL

Each KDV Hariç

21,16 TL

Each KDV Dahil

Siyah Buton Kapağı (Kep), KSA ve KSL Serisi Yalıtımlı Tact Switch İle Kullanım

17,63 TL

Each KDV Hariç

21,16 TL

Each KDV Dahil

Siyah Buton Kapağı (Kep), KSA ve KSL Serisi Yalıtımlı Tact Switch İle Kullanım
Stok bilgileri geçici olarak kullanılamıyor.

Teknik Belgeler

Özellikler

Başlık Rengi

Siyah

Aksesuar Tipi

Button

Marka

C & K

Şununla Birlikte Kullanım İçin

KSA ve KSL Serisi Yalıtımlı Tact Switch

Menşe

France

Ürün Ayrıntıları

Electronic Converter for MR16

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.